![]() In other words, if you want to go directly from the instrument to the mixing console or audio interface, you will need a DI box. This is where the DI box came into play, which is still needed in most cases today. preventing any loading down of passive pickups when connected to an amplifier and. However, since the electrical signal from a music instrument is not necessarily compatible with the output signal from a microphone, a special signal converter box was needed. The active DI portion of the Reamp Station is based off Radials. electric guitar) into the mixing console. This was done by directly feeding the electrical signal generated by the electronic instrument (i.e. Then someone came up with the idea of skipping the conversion of the electric to acoustic signal through a loudspeaker/microphone. As the first electronic instruments emerged, a microphone was simply placed in front of the sound source, i.e. In the "electronic stone age", only acoustic instruments were recorded with a microphone. Shipping size (L x W x D): 5" x 2.75" x 10.The simplest way to give you a clear picture of when you would need one is to look at how they developed.Construction: 14 gauge steel chassis & outer shell.Output Connectors: 1/4" Isolated and Direct.180° polarity reverse, Ground lift, Level Control.Intermodulation Distortion: 0.02% -20dBu.Total harmonic distortion: 0.02% -15dBu.Frequency response: 20Hz ~ 15kHz (± 1.0dB).Audio circuit type: 100% discrete class-A.I-Beam construction prevents circuit board from torque which could lead to part failure. Provides 100% isolation to eliminate hum and noise caused by ground loops.Īpplies to guitar amp output 2 - provides alternate ground path if needed or can help eliminate ground loops.ĭouble-sided military spec for greater durability and full ground plane to reduce radio frequency interference. Tougher than steel.įull sized parts are hand inserted to deliver the very best audio quality. Nylon XLR connector with extra large nickel-silver pin contacts. Transformer isolated output is used to feed your second amp while eliminating ground loops. It can also be used to create different effects. ![]() Reverses the absolute phase on output 2 so that both amplifiers play in phase. This should be a properly grounded amp that has passed local safety approvals. When this light goes on, turn down the source! You are overloading the X-Amp input circuit.ĭirect buffered output is used to feed your first amp. Lets you adjust the X-Amp output level going to the amplifiers. Lets you know the X-Amp is on and ready to use. Neoprene isolation pad provides electrical isolation from the chassis and mechanical insulation from rough handling.Īutomatically illuminates when the power supply is connected. Lifts pin-1 ground on the XLR input, diverting the ground connection to the ¼" OUT-1. ![]() Follows AES standard with pin-1 ground, pin-2 hot (+), pin-3 cold (-).
0 Comments
Leave a Reply. |